Digi SM-5100 - Page 93

SM – 5100 Operation Manual
93
4.19.3 Programming Order
1) After filling a section, programming status (the position of the cursor) moves to the next dot
automatically.
2) When the programming status reached to the last dot (128 horizontal dots), or [*] key is
depress, the programming status moves to the first left section on the next upper line
automatically.
4.19.4 Program Logo File
At Programming Mode, select Logo programming mode and enter new Logo number. (Ex. 1)
*For edit, enter existing Logo number.
OPERATION
DISPLAY
REMARK
PT
kg
＄/kg
＄
S1
→
PLU
FILE
Enter S mode.
[1][7][*]
S17.0
LOG
O
0
NO
SET
Enter Logo File programming mode.
Enter Logo File number.(Ex. 1)
[1][*]
S17.1
LOG
O
0
X-POS
Enter X position.(Ex. 7 dots)
[7][*]
S17.2
LOG
O
0
Y-POS
Enter Y position.(Ex. 1dots)
[1][*]
S17.3
LOG
O
000000
007-01
Set Fill or Clear dots you want and the save
the setting and go to next upper line (Y
02).(Ex.11101110001)
[1][1]……[0][1][*]
S17.3
LOG
O
000000
001-02
Press [>>] key to move the cursor to next
dot.
Press[>>]key 6
times
S17.3
LOG
O
000000
007-02
If necessary to change the position of the
cursor been set, the following procedure is
required.
[－][－]
S17.3
LOG
7
X-POS
Change the Horizontal start position (Ex. 5