Digi XPress - Issuing a Factory Reset; Update Firmware

©2013DigiInternational,Inc. 15
XPress™EthernetBridgeGettingStartedGuide
Issuing a Factory Reset
TheXPre ssEthernetBridge(XEB)comesinaplasticIP67‐ratedindustrialcaseprovidingtheradiosome
protectionfromdust,rain,andotherharmfulcontaminants.Thisenclosurealsoprovestobeabarrierto
youwhiletryingtoissueafactoryresettotheradio.
What You’ll Need
(1)4"Phillipsscrewdriverwitha#1tip
Reset
1.MakesureXPressEthernetBridgeXEBisunpluggedandpoweredoff.
2.Fi
ndsixholesonthebottomoftheXEB,whichshouldbefairlydeep.
3.Re
movethescrews,usingmoderatetoheavypressuretoavoidstrippingthescrews.
4.Re
movethelidandlocatetheWHITERESETbuttonontheboard.
5.R
econnectpower.
6.Pr
essandholdthewhiteresetbuttonfor10seconds.ThiswillcausetheLEDstoflashoffthenback
on.Theradioisnowsettofactorydefaults.
Update Firmware
DigiXpre ssEthernetBridgeradioshaveawebbrowserinterfacethatincludesthecapabilityofupgrading
newfirmware.Thefollowingstepswillguideyouthroughtheupgradeprocess.
Note:An
ycustomerswhousethecryptomoduleortheinternationalvariantof
theXpress(XEB09‐CIPA‐W)mustcontactDigitechnicalsupportforfirmware