Page 46
16.6 ADV-SETUP PARAMETERS MENU (ADVANCED SETUP)
The following is a list of parameters that can be adjusted. For each parameter you can see the range of values, the
factory setting (default) and the unit of measure.
n Name Description Range Default Unit
1 PITO pitot tube habilitation ON/OFF OFF ----
2 KMAG magnetic compass calibration 0 – 100 % 100 km/h
3 KIAS anemometer calibration 0 – 100 % 100 %
4 KBAR barometer calibration +/- 20.0 0.0 mB
5 GCAL AHRS calibration MAN/AUT AUT
6 GPOS AHRS spacial position LEFT/CENT/RIGHT CENT
7 EFF real time medium glide ratio 1 - 30 3 sec
8 EFFA medium glide r.for HW calc. 1 - 100 15 sec
9 POLA active polar OFF/P1/P2/P3 OFF ----
10-11-12 P1-A P1-B P1-C polar 1 coefficient xxx ----
13-14-15 P2-A P2-B P2-C polar 2 coefficient xxx ----
16-17-18 P3-A P3-B P3-C polar 3 coefficient xxx ----
19 MCRA McCready average time 0.2 - 30 10.0 min
20 MCRE McCready equiv average time 0.1 – 3 0.4 sec
21 IFLY intelliflight mode ON/OFF OFF ----
22 WSEN wind calculator sensibility 3 – 15 5 ----
23 CORD GPS coordinates’ type lat lon DMM/DMS/UTM DMS ----
24 TELE telemetry output habilitation OFF/CAR/FL1/FL2 OFF ----
25 BLUT bluetooth enable OFF/ON OFF ----
16.7 RESTORE FACTORY SETTINGS (DEFAULT PARAMETERS)
To restore the factory settings (default parameters) and default screen setups, turn on the instrument pressing
at the same time the keys and until the message “FACTORY SET?” appears.
If you want to confirm press the key it will appear the message “SETUP RESET”. Otherwise, press the key
to quit the restore.
16.8 RESET
In case of a system crash, to reset the instrument, press at the same time the arrow key and the power on
key for over 4 seconds.
Air User Manual R52a
To Previous Page
Loading...
