Page 8
2.6.2 ALPHANUMERICAL FIELDS EDITING
The alphanumerical fields editing is different from the standard one described in the above paragraph,
because it is possible to modify every single character of the field.
To modify the field press the key (“EDIT” function) to activate the edit mode.
Use the arrow keys to change the character shown in reverse mode on the display, every parameter’s
change is automatically saved (“AUTOSAVE” function), a longer press of the arrow keys activate the quick
parameter’s change (“AUTOREPEAT” function),
Pressing the key, it is possible to shift to the character on the right to edit it, repeatedly pressing key it
is possible to scroll toward right all the field’s characters to come back to the first of the field. A longer press
of the key comes back toward left. To exit press the key.
2.7 MULTI LANGUAGE HELP
In the menus are visible some help messages, e.g.: help to set the parameters. For these messages it is
possible to set the preferred language entering in the MAIN SETUP menu (MAIN SETUP \ n. 2 LANG) then
select the language you prefer and confirm.
IMPORTANT: after every firmware update, it is necessary to update also the help file containing the messages.
The help file update can be done from your PC using the Digifly AirTools, function: “upload HELP”.
2.8 RESTORE FACTORY SETTINGS
To restore the factory settings (default values for all parameters), turn on the instrument pressing at the same
time and holding down the keys & until the message “FACTORY SET?” appears. To confirm press the
key and the display will show the “SETUP RESET” message, to avoid the restore press the key.
2.9 RESET
If a system crash would occur with a consequent instrument’s block, to reset its functions press at the same
time the keys: and holding them pressed for more than 4 seconds.
To Next Page
Loading...
