How can I set the network protocol (Z21, XpressNet, etc.)?
This short manual does not replace the complete DR5000 manual, but only complements the exis+ng documenta+on.
&!+.+!''&,! .$ '*,!'&<2+' "!& ! 'R +''.$$-+" !+'&I+++A
-+''& *!$'$,!USB always required
Op'on 1:
Change '&+' $ '*"'& !++-+''&&network via a router:
'!/*&USB ++-+'&O
LAN +' "!"'&''&&+' 7 .' :
&&+' .' !+!+! ''&&$ + !**%'!!/.'4+
4 1$+'&Tool7++-+'%$*.'/''F@?:
5 1$+LAN I++*
@*''& D. $ '*
P +J '&*-+'&'&green -
Q ''!!$$ MP+.+-*'&<2.*"'& '! '
&!++.+!'.+'&*'$ '*
Op'on 2
Change '&+' $ '*via WLAN:
'!/*&USB ++-+'&O
'&.'/connected ''&2"'&
K %.&!,".+'&E2+' +'&Windows network dialog *!++' '&2
$! (Factory seng 12345678)
&++-+**+/'!/*&&$ + !**%'!!/.'4+
4 1$+'&Tool7++-+'%$*.'/''F@?:
5 1$+LAN I++*
@*''& D. $ '*
P +J '&*-+'&'&green -
Q ''!!$$ MP+.+-*'&<2.*"'& '! '
&!++.+!'.+'&*'$ '*
1
1
2
2
2
1
3
3
"'&is not ++',!'&!++' "!''&home network 7 .' : ,!Wlan ''& *!$'$)'&!+I+"'&are grayed
out and not accessible!+'& " cannot /&!+O++-+,!USB ''&is always required to change '&!+I+O
*!$!%!0+-+O