Digikeijs DR5088RC DIGIDETECT

DR5088RC DIGIDETECT 30.05.2019
P 42
www.digikeijs.com
7.5.1 Windigipet® 2015
Windigipet® can evaluate the DR5088RC, but this is only possible with version WDP 2015.2b. For this, the DR50088RC must be congured in such a way that it
funcons as a "Blücher®" feedback module and that the evaluaon of the Railcom direcon is not interrupted.
"in locomove address".
1. IZNF properes.
2. Select the desired digital system in the train number recognion. This is the DR5000.
3. Select interface 3 for Address.
Since WDP in interface 1 unfortunately does not support port 1, it is recommended to congure the
DR5088RC so that it starts with block address 17 at the feedback unit. For this reason the rst module
should get the block addresses 17-32.
Important! In the mode Detecon of derailing direcon "in locomove address" only DCC locomove
addresses up to 4096 can be used.