Digital Alert Systems DASDEC II - Setup > Email; Email Server

Digital Alert Systems: DASDEC User Manual
35
E. Alert storage management setup
F. Networked GPIO setup
Basic Operation Level:
A. Can encode and forward alerts and run local access forwarding interface.
B. No Setup operations.
EOC Operation Level:
View Level:
A. Decoded, originated and forwarded alerts and status can be viewed.
B. No Setup operations.
C. No alerts can be originated. No manual forwarding.
4.5 Setup > Email
The DASDEC II can be configured to optionally send email upon alert decoding, origination, and forwarding.
Select the Setup > Email page to configure an outgoing email server and to configure the send options. There
are four tabbed sections: Email Server, Event Email, Decoder Email, and Encoder Email.
4.5.1 Email Server
To set the outgoing email server name without using authentication (port 25):
 Select Setup Email >Email Server. From this page you can set the name of the SMTP server for
outgoing Emails from the DASDEC II
SE
. Enter a name in the text field after Outgoing Email Server
and click Set & Test Mail Server Name
.
 The DASDEC II will attempt to contact this Email server.
 If it succeeds, the message "OK: Contacted Email Server" will display under the name.
To test if Email can actually be sent via the chosen Email server, type a valid Email address in the To: text
field and click Send Test Email
. If this works, the chosen recipient should receive an Email.
Setup > Email > Email Server: Not using authentication