Digital Dream DM500 - User Manual

Handheld Motion Controller
For Engraving Machine
DM500
User’s Manual
The version of 20170806

Summary

DM500 Motion Controller Introduction

Introduction of Product

Performance Parameters

Wiring Overview

Wiring Board Interface

Wiring Board Ports Definition

Wiring Board Ports Description

Input Ports Wire Method

Describes how to wire the input ports of the DM500 controller.

Output Ports Wire Method

Details the wiring procedures for the output ports of the DM500 controller.

Pulse and Direction Output Wiring

Explains the wiring for pulse and direction signals for motor control.

File Page Operation

Parameter Page Operation

Motion Controller Operation

System Status

System Preparation

Axis Direction and Pulse Adjustment

Covers how to set axis direction and adjust pulse equivalents for accurate motion control.

Hard and Soft Limit Function

Running G-Code Files

Start Running G-code

Guides on how to initiate the execution of a G-code file.

Load G-Code File

Guides on loading G-code files from a U-disk into the controller.

Run G-Code File

Explains how to preview, simulate, and run G-code files.

Machine Zeroing

All Axis Find Machine Zero

Explains the process of establishing the machine's home position for all axes.

Single Axis Find Machine Zero

Workpiece Preparation

Workpiece Coordinate Selection

Guides on selecting the appropriate workpiece coordinate system (G54-G59).

Workpiece Zero Point Setting

XY and ZA Axis Zero Clearing

Tool Functions

Automatic Probe

Introduces the automatic probe function for measuring tool positions and thickness.

Fixed Tool Sensor Position

Explains how to set up the tool sensor when its position is fixed.

Floating Tool Sensor

G-Code File Operation

Feed Rate Override (FRO)

Spindle Speed Setting

Extended Input;Output Ports

System Update

Parameter Management

Parameter Revision

Explains how to modify or revise existing parameters in the controller.

Parameter Backup

Guides on how to back up controller parameters to a U-disk.

Data Recovery

Password Setting

Programming

G-Code Reference

M-Code Reference

Digital Dream DM500 Specifications