Web Power Switch 7
5
LAN. Switch power on. If you are connected to a switch,
you may need to cycle power to the switch to establish a
connection.
4. Ping the default address: 192.168.0.100 to confi rm a
network connection is established. If you don’t receive a
response, see the IP Setup section below.
5. Log in to the power controller using the default user name
admin and the password 1234
“admin” must be entered in lower case.
6. Click on the Settings link to reach the confi guration page.
7. Select the safest power-loss confi guration for your
installation: (all OFF, all ON, or sequential ON)
8. Confi gure the power switch as described below. After
each change, click Submit and wait for the page to refresh
before continuing.
Tips:
• A three-bulb electrical safety-tester is handy for confi guring
the controller before attaching your equipment.
• Please register your product for better support and free
fi rmware updates
IP Setup
If your network settings won’t access the default IP, use a direct
cable connection (temporarily bypass any switch or router)
and follow these steps to add a compatible static IP such as
192.168.0.50 Before adding an IP, close programs and browsers.
After the link is established, you can revert to DHCP if desired or
use a combination of DHCP and static IPs.
To Next Page
Loading...