Web Power Switch 7
www.digital-loggers.com
6
Windows Step 1
In Windows, the fi rst step is locating the network adapter TCP/IP
properties. The procedure differs for each Windows version:
Windows XP, 2000, 2003: Open Start / Control Panel / Network
Connections. If you’re using “classic view”, it’s Start / Settings /
Control Panel /Network Connections. Right-click on Local Area
Network Connection and select Properties. Proceed to step 2.
Windows Vista: Open Start, right click on Network, then on
Properties. Double click Network and Sharing Center, click
Manage Newtork Connections. A Network Connections window
appears. Right click on the network connection to the switch, ie.
Local Area Network. Proceed to step 2.
Windows 7: Use the default Category View. Open the Start orb,
click on Control Panel. Click View Network Status and Tasks,
then Change Adapter Settings. Proceed to step 2
Windows 8: Mouse or swipe to the bottom right corner and select
Settings. Select Control Panel. Select Network and Sharing
Center. Change Adapter Settings. Right click on your connected
network and select Properties. Proceed to step 2
Windows 10: Select Start -> Settings -> Network and Internet
-> Ethernet. Then click “Change Adapter Options” to set IPs.
Windows Step 2
The second step is adding an IP such as 192.168.0.50. If you are
using DHCP, it’s easiest to temporarily disable it while confi guring
the switch.
Select Internet
Protocall TCP/IP
V4 Properties and
click Properties.
Enter a compatible
static IP such
as this:
To Next Page
Loading...