Where to put your radio
It is important that you consider carefully in advance where
your radio will be situated and make sure that it is:
* on a at and stable surface
* within 1.5 metres of a power socket
* where you can fully extend the telescopic aerial
* away from bright sunlight or heat sources, such as a radiator
* not in a humid or very damp place such as a bathroom
Setting up
Step 1: Connect the mains power lead into the socket on
back of the radio and fully extend the aerial in a vertical
position to obtain the maximum signal strength.
Note: Only use the power supply provided. Using an
unauthorised power supply will invalidate your guarantee
and may damage your radio.
Step 2: Plug the power adaptor into the mains power wall
socket and switch on.
Step 3: When switching on for the rst time, slide the power
switch on the back of the radio, to ‘On’. ‘Welcome to Digital
Radio’ will be displayed and your radio will automatically
begin to scan for DAB+ radio stations. A progress bar will
show the progress of the scan and the number of stations
found during the scan will also be displayed.
When the scan is complete your radio will select the rst
available station and begin to play. Stations are listed in
numerical and then alphabetical order by default.
Note: The DAB+ radio station list is stored in the memory
and so the next time you switch your radio on, the station
search does not take place. It is possible to scan manually for
stations. Please see page 6.
Step 4: Inserting the batteries (optional). Before installing
the batteries (not included) please ensure that the DAB+
Radio is unplugged from the mains power supply.
On the back of the radio, push in the tab to remove the
battery compartment. Insert 4 x AA batteries, making sure
to note the ‘+’ and ‘-‘ markings and position the batteries the
correct way around. Replace the battery cover, making sure
it ‘clicks’ shut.
Product Set Up
Harlequin DAB UG.indd 3 12/12/12 18:46:48
To Next Page
Loading...