DIGITAL RADIO MAGICBOX - DAB+ Station Management; Pruning DAB+ Stations; Presetting DAB+ Stations

7
1. If you are not already in DAB+ mode, briey press the ‘Mode’
button to go to DAB+ mode.
2. Press the ‘Scan’ button to begin a local search for stations.
The display will change to ‘Scanning...’. A progress bar will
show the progress of the scan and the number of stations
found during the scan will also be displayed. A local scan
takes approximately 10 seconds.
3. Press the ‘Menu’ button, followed by the ‘Enter’ button to begin
a wider, national and local scan. The display will change to
‘Scanning...’. A progress bar will show the progress of the scan
and the number of stations found during the scan will also
be displayed. A national and local scan takes approximately 1
minute but can take up to 3 minutes.
Prune DAB+ stations
You can remove the DAB+ stations in the station list that
cannot be received in your area. These are listed with a ‘?’
prex.
1. Press the ‘Menu’ button and use the or button to scroll
to ‘Prune’. Press the ‘Enter’ button.
2. ‘Prune <No> Yes’ is displayed. Use the or button to
scroll to ‘Yes’. Press the ‘Enter’ button to prune the station
list. Stations with a ‘?’ prex will now no longer be displayed.
Press the ‘Menu’ button to return to the station display.
Storing a DAB+ station preset
Your radio can store up to 10 DAB+ stations in its preset
memories for instant access to your favourite stations.
Note: When you store DAB+ radio station presets, these do
not overwrite your FM station presets.
1. Tune your radio to the station that you wish to preset (see
changing DAB+ stations on page 6).
2. Press and hold the ‘Preset’ button on the front of your radio.
‘Preset Store 1 Empty’ is displayed if no previous station has
been stored.
3. Use the or button on the front of the radio to scroll
to the Preset location that you would like to store the radio
station to (1 - 10).
4. Press the ‘Enter’ button, the display will conrm ‘Preset X
stored’, where ‘X’ is the number of the preset (1-10).
Note: If there is already an existing DAB+ station stored
under a preset, it will be over written when you store the new
station.
Tune to a DAB+ preset station
In DAB+ mode:
1. Press the ‘Preset’ button. ‘Preset Recall 1’ is displayed and the
name or frequency of the station stored there, or ‘Empty’ if no
previous station has been stored.
Harlequin DAB UG.indd 7 12/12/12 18:46:53