If Manual Config. has been selected, setup the information below:
NETWORK TYPE
• Select either STATIC IP or DHCP for dynamic IP. For proper configuration, it is
recommended to assign the DVR a DHCP address and let the DVR auto-discover all the
proper network settings, and then change the Network Type to Static IP and save the
changes.
• DHCP: the DVR will automatically configure the network settings according to the
current network requirements. If DHCP is selected, click the ‘IP DETECT’ button to
automatically detect all the network settings.
• STATIC IP: manually enter all necessary network settings. While set to STATIC, the
network settings will not change when prompted by the connected DHCP router or
DHCP network device.
IP ADDRESS
Displays the DVR’s IP address. If DHCP is selected, the IP address will automatically adjust to
match the network’s requirements. If STATIC is selected, the IP address can be manually
changed as needed.
SUBNET MASK
Subnet Mask classifies the subnetwork that the DVR system belongs to. For more
information, please consult your network administrator or your internet provider.
GATE WAY
This is the IP address of the router or gateway server. It is required when connecting to the
DVR through the external router over the Internet (from another network). For more
information, consult your network administrator or your internet provider.
DNS SERVER
Enter the IP address of the Domain Name Server (DNS). You should input the DNS Server
information to use DDNS, Email Notifications and NTP Server. For more information, please
consult your network administrator or your internet provider.
TCP/IP PORT
(Default – Port 9010) Input the network port number that is used when connecting to the
DVR locally or remotely. If your ISP blocks Port 9010, you may either port forward the
To Next Page
Loading...
