3.2.2. Icons
In Live mode, icons will appear on the screen to notify of the system mode or status.
The icon is shown at the right-upper
corner of each channel screen
The icon is shown at the right-bottom corner of
fullscreen
Continuous Recording
No HDD Detected
Motion Detection Recording
Emergency Recording is in use
Sensor Activated Recording
PTZ is enabled
Continuous + Motion Alarm
Recording
Warning for exceeding
temperature
Continuous + Sensor Activated
Recording
Sequence Mode is enabled
Motion Detection + Sensor-
Activated Recording
Digital Zoom is enabled
Emergency Recording
Sensor Activated
Motion Detected
Audio Channel
PTZ Camera
Transaction Verification
If you cannot find any recording icon in the right corner of the screen, the system is
not recording. Check the recording schedule or camera in the main setup menu.
3.2.3. Pop-up Menu
Users can click the right button of the mouse to pop up the sub-menu as below. If users want to
control a specific channel, put the mouse cursor on that channel and then click the right button.
Display Mode
The user can change the screen display mode from the available split
options (1, 4, 6, 9, 10, 13, 16 split option).
Change Next CH
View the next channel or next group of cameras in the current split
mode.
Sequence
When SEQUENCE is selected, icon will appear on the right-
bottom corner of the screen. The display screen will be sequentially
changed.
Digital Zoom
• Digital Zoom is available in a single-channel view only. When
“ZOOM” is selected, an icon will appear on the right-
button corner of the screen and digital zoom control is available.
• To zoom in, click-and-drag the mouse over the desired area to
To Next Page
Loading...
