Protocol
Communication protocol between DVR and transaction verification device.
Save
Enable or disable the DVR to save the transaction data.
Show
Enable or disable the DVR to display the transaction data.
Setup
Click to open the Transaction Verification Settings
menu which includes:
• NO: ID# of transaction verification device.
• Camera: Select the camera to assign to the
transaction verification device.
• Type: Select COM (RS-232) or TCP/IP (LAN)
• Device IP: Input the IP address of the transaction
verification device when it is connected through
the network.
• Protocol: Communication protocol between DVR
and the transaction verification device.
1. Tex t -in: Receive ASCII characters.
2. SDVR-POS: Manufacturer’s protocol.
Contact your transaction verification dealer for information.
• Start character: Input the assigned character to start display and save. If there is no
input, the system will display and save all data without classification per transaction.
• End character: Input the assigned character to terminate the display and save. It must
have a start character to work correctly.
• Line break: Set the line change character. (It should be 16 digits HEX Value.)
1. CRLF, CR, LF: The character that is generally used in ASCII-type transaction
verification. (Please contact the transaction verification manufacturer for the
detail.)
2. Custom: It can be used except for the above general character. Only numbers
(0~9) and the alphabet (A ~ F) can be used and even numbers should be input.
For example Hexadecimal: 0x0D 0x0A → 0D0A
• Save: Save the transaction verification data.
Live Display Settings
• Display line: Set the number of lines to display on the screen.
To Next Page
Loading...
