DigitalZone HVP-7004N - User Manual

• M

  Melissa BrownAug 11, 2025

  What to do if there is no display on DigitalZone TV Tuner?

  

  Same questionReply

  • M

    Michael FigueroaAug 12, 2025

    If you're not seeing a display on your TV when using the DigitalZone TV Tuner, here are a few things to check: - Ensure your TV is powered on. - Verify the correct input selection on your TV (use the 'External Input' button on your TV remote). - Check the connection between the TV and the UHD Stream Generator. - Try pressing the [DEFAULT] button on the remote (this will output 1080p60). - Confirm that the HDMI input port on your TV matches the output port. - Check the front LEDs to ensure the Generator is running properly (during normal operation, the Power LED should be green, and the front LEDs should be on FHD or UHD and one of 24, 30, 50, 60).

    

    Reply
• M

  Michael RichardAug 17, 2025

  What to do if remote doesn’t work with DigitalZone HVP-7004N TV Tuner?

  

  Same questionReply

  • H

    harveydavidAug 17, 2025

    If your remote isn't working with the DigitalZone TV Tuner, try these steps: - Make sure you're pointing the remote at the UHD Stream Generator at a reasonable distance and angle. - Replace the remote's battery.

    

    Reply
• K

  Kelly ChristianAug 23, 2025

  What to do if there is no audio on DigitalZone HVP-7004N TV Tuner?

  

  Same questionReply

  • J

    Jay MccarthyAug 23, 2025

    If you're not getting any audio from your DigitalZone TV Tuner, try the following: - Press the [MUTE] button on both your TV and the UHD Stream Generator. - Adjust the volume on both your TV and the Generator.

    

    Reply
• B

  Bryan GordonAug 29, 2025

  What to do if DigitalZone HVP-7004N TV Tuner shows error for disk partition number?

  

  Same questionReply

  • R

    robinwhiteAug 29, 2025

    If your DigitalZone TV Tuner shows an error related to the disk partition number, it indicates a damaged HDD partition. It is necessary to format HDD (E-mail to sales@dzonei.com).

    

    Reply
• J

  Jonathan SmithSep 4, 2025

  What to do if DigitalZone HVP-7004N shows partition file system error?

  

  Same questionReply

  • D

    Dr. Christopher WilkersonSep 4, 2025

    If your DigitalZone TV Tuner displays a partition file system error, this means that the HDD file system is damaged. It is necessary to format HDD (E-mail to sales@dzonei.com).

    

    Reply

DigitalZone HVP-7004N Specifications

General

TV Tuner Type	Hybrid
Interface	USB
Supported TV Standards	NTSC
Video Formats	MPEG-2, MPEG-4
Operating System Compatibility	Windows XP, Windows Vista, Windows 7, Windows 8, Windows 10