Installation and Operation (Receiver)
For best results, the receiver should be placed at least 1m off the ground, and should
not be placed directly in front of the speaker system.
- Connect the antenna, a balanced cable AF line (not supplied) to your
speaker or amplifier system, and plug in the power adapter.
- Adjust the antenna so that it is vertical.
- Switch on the power, and while it is in stand-by, turn on the power of your
speaker or amplifier system.
- Ensure not to use two machines with the same frequency at the same place
at the same time.
Installation and Operation (Transmitter)
- Open up the battery compartment of the microphone, insert 2 x AA
batteries and close the battery compartment.
- Switch on the power and the power light will flash once.
- The signal level on the receiver will light up to indicate that an effective
signal is being received.
- Adjust the channel volume and the volume on your speaker or amplifier
system.
- When the AF level lights up corresponding to the volume, the system is
functioning normally.
Distributed by:
TechBrands by Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Int’l: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com
To Previous Page
Loading...