Resetting the device
Reset the device if it behaves unexpectedly. Resetting the device will remove all
information about paired devices.
To reset the device:
In standby mode, press and hold the Track Forward (Volume Increase), Multifunction, and
Track Backward (Volume Decrease) buttons simultaneously until the LED flashes red and
blue alternatively and a ‘beep’ sound is heard, and then release the buttons. Turn your
phone Bluetooth® technology off and then on again. You will need to pair the device again.
Wearing Instructions
To get the best performance from the device when using it outdoors, it is recommended
that you carry your phone on the same side of your body as the device.
Call Instructions
With a built-in microphone, the device enables you to receive and make calls while listening
to music when paired with a smartphone.
Answering a call:
The LED will flash blue and the incoming call signal will sound. Press the Multifunction
button once to answer the call.
Ending a call:
Press the Multifunction button once to end the call.
Declining a call:
Press and hold the Multifunction button and release it after sound indication is heard.
To mute the call (mutes both parties):
Press and hold the Track Forward button and straight away press and hold the
Multifunction button at the same time. Release the buttons after a sound indication is
heard. Repeat these steps to cancel the mute.
To redial the last dialed number:
Double press the Multifunction button to redial the last dialed number.
To transfer a call to the phone:
Press and hold the Multifunction button for 3 seconds during a call to transfer the call to
the mobile phone. Repeat the procedure to transfer the call back to the device.