1. Turn OFF the main power of the E-bike before plug / unplug the HMI, or it may
lead to permanent electrical damage to the HMI and the E-bike.
2. Do Not overtighten the bolts when installing the HMI to the E-bike, a torque of
0.2N.m is sufficient to secure the HMI to the handlebar, overtightening the bolts
may cause damage to the HMI.
3. Do not immerse the unit in water or clean it with pressurized water. Clean the
unit using a soft cloth dampened only with water. Do not use any detergents.
4. The USB port, when exposed, does not provide water protection. When riding in
the rain, an external device must not be connected and the USB Cap must be
completely closed and sealed.
5. Do not dispose HMI or any other e-bike components into house-hold wastes,
follow your local regulations and dispose them in an environmental-friendly
manner.
6. Damage / malfunction caused by improper installation or usage are not covered
by after-sales service.
To Next Page
Loading...
Need help?
General
