DigiTech B-COCKPiT BC-18 - Installation; Install the BC-18 Unit; Connect the cables

B-COCKPiT BC-18 Operating Manual
7
Digitech Co., Ltd. www.riding-evolved.com
 Installation
 Install the BC-18 Unit
1. Use M3 Hex Socket Screw 1 to secure the mounting bracket to the left side of the handle bar.
Tightening torque: 0.2N.m. Do Not Overtighten or it may cause damage to the HMI
 Connect the cables
1. Securely connect the cables of B-COCKPiT with E-bike controller by aligning the 2 arrow marks.
1
Arrow mark
Arrow mark