DigiTech CG Wizard - User Manual

P a g e 1 | 11
User Manual
Version 1, May 2017
Dear user
Thank you for using CG Wizard, this tool has been made to ease the process of balancing a plane.
In this manual there is a description of the different components of the CG Wizard and a quick start
procedure as well.
Should you have any questions regarding the use of this tool, you can refer to the video tagged by the
following QR Code or contact us by email to support@digitech.nl
This tool has a laser pointer included, please do no stare into beam.

DigiTech CG Wizard Specifications

General

Brand	DigiTech
Model	CG Wizard
Category	Test Equipment
Language	English

Summary

Components Descriptions

Central Box

The core of CG Wizard with 4 connectors for sensors and power bank.

Sensors

Three sensors calibrated for specific connectors, identified as 'Left', 'Right', and 'Front'.

Power bank

Used to power the whole system and recharge.

Application

Supports iPhone and Android, with QR codes for app downloads.

Quick start guide

Step 1

Mark the center of gravity line on the fuselage as per constructor.

Step 2

Connect components, power on, launch app, and do not place plane on sensors yet.

Step 3

Place the plane on the sensors and proceed to measurements.

Step 3.a

Measure the distance between rear ends of main sensors and front sensor for sensors spacing.

Step 4

Use the laser pointer to aim at the line previously drawn in Step 1.

Step 4.a

Measure perpendicular distance between reference notch and drawn line for target distance.

Step 5

Adjust weight to match the balance point shown in the app with the target distance.