8
ANTI-SKATING ADJUSTMENT
TO ADJUST THE ANTI SKATING MECHANISM, TURN THE ANTI-SKATE KNOB TILL
THE INDEX LINE AGAINST “0”. TURN THE ANTI-SKATE KNOB TO ADJUST
TRACKING FORCE IF NECESSARY.
PICKUP SELECTOR
- PICKUP SELECTOR IS LOCATED ON THE TURNTABLE DECK.
- SELECT “PHONO” FOR BUILT-IN PRE-AMPLIFIIER, OR SELECT
“LINE” FOR CONNECTION WITH SUITABLE EXTERNAL PRE-
AMPLIFIER VIA RCA JACK.
- IF CHANGE TO OTHER NEEDLE OR CARTRIDGE, PUT A SCREW
DRIVER INTO PICKUP SELECTOR TO SELECT “LINE”. IN THIS
CASE, CONNECT THE PRODUCT WITH SUITABLE EXTERNAL
AMPLIFIER (DEPENDS ON THE SPECIFICATION OF THE OTHE
NEEDLE OR CARTRIDGE) VIA RCA JACK.
- PRESS FUNCTION BUTTON TO SELECT “PHON” ON DISPLAY.
- REMOVE THE STYLUS PROTECTOR.
- BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE
TONE ARM REST PART BEFORE OPERATING AND RE-SECURED
AGAIN AFTERWARDS.
- PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE ARM FROM
THE ARM PARK, AND THEN SLOWLY MOVE IT TO THE RECORD SIDE. THE PLATTER WILL START TO
ROTATE.
- PUT DOWN THE LIFT LEVER TO DROP THE TONE ARM AND TOUCH THE RECORD GENTLY. PHONO
PLAYING STARTS NOW.
- PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE ARM FROM THE ARM PARK, NOW PLATTER WILL
STILL BE ROTATING BUT PHONO PLAYING WILL STOP. TO CONTINUE THE PLAYING, THE USER NEEDS
TO PUT DOWN THE LIFT LEVER.
- PRESS 33RPM SPEED SELECT OR 45RPM SPEED SELECT BUTTON DEPENDING ON THE RECORD
TO BE PLAYED, BUTTON INDICATOR WILL LIGHT UP.
- PRESS START / STOP BUTTON, TURNTABLE WILL STOP ROTATING GENTLY. PRESS START /
STOP BUTTON, TURNTABLE WILL ROTATE AGAIN.
- STROB DOTS ON THE TURNTABLE PLATTER FOR SPEED CHECKING. UPPER TWO ROWS FOR
50HZ, LOWER TWO ROWS FOR 60HZ. BIGGER DOTS FOR 45RPM, SMALLER DOTS FOR 33RPM.
SUITABLE DOTS WILL KEEP STABLIZED IF THE SPEED IF CORRECT. ADJUST SPEED BY PITCH
CONTROL SLIDER (+/-10%).
- PRESS TARGET LIGHT SWTICH, TARGET LIGHT WILL LIGHT UP; PRESS TARGET LIGHT
SWTICH AGAIN, TARGET LIGHT WILL BE OFF.
- USE THE 45 RPM ADAPTOR IF REQUIRED.
- ADJUST THE VOLUME TO THE DESIRED LEVEL.
- AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING, TONE ARM WILL
AUTOMATICALLY RETURN TO THE TONE ARM REST PART. TRIGGER THE EJECT SWITCH DURING
RECORD PLAYING, TURNTABLE WILL STOP GENTLY AND TONE ARM WILL UTOMATICALLY RETURN TO
THE TONE ARM REST PART.
To Next Page
Loading...