20
the LED movement will slow down. When the LED array stops moving,
the note is in tune.
4. Continue to tune the rest of your strings in the same fashion.
5. When tuning is complete, press the Foot Switch to bypass the tuner.
SINGLE NOTE TUNING TIP: For the best results when tuning individual strings, try to mute any
strings that are not being tuned.
TROUBLESHOOTING TIP: If the tuner is not responding as expected, it may be that the
Tuning Display Mode (i.e. Bass, Guitar or Custom), the Tuning Reference, or the Fret Offset is set
incorrectly. If you are experiencing problems try this:
1. Select the correct Tuning Mode for your application (see page 9).
2. Configure the pedal for the desired Tuning Reference (see page 10).
3. Assign the Fret Offset if using a capo or other lowered tuning (see page 21).
To Next Page
Loading...
General