DigiTech HARDWIRE HT-6 - Setting the Fret Offset; Setting The Fret Offset Automatically

To Next Page

To Previous Page

Setting the Fret Offset

The Fret Offset mode works by setting the expected notes for each string to be

a fixed offset (in semitones) from a standard setting. This is a useful feature for

guitarists who occasionally use a capo or a guitar tuned down 1/2 or a whole

step during a performance. Changing the Fret Offset can be accomplished either

automatically or manually.

Setting The Fret Offset Automatically

1. If your guitar is already roughly in tune (for example you just placed

a capo on the guitar), you can automatically set the offset by holding

down the Foot Switch.

2. After 2 seconds, the LED Matrix Display will show “FRET” and the

Note Display will show the current offset (usually 0 if being set for

the first time).