DigiTech HARDWIRE HT-6 User Manual

23
Setting The Fret Offset Manually
1. Hold down the Foot Switch until the LED Matrix Display shows
“FRET” and the Note Display shows the current offset (usually 0 if
being set for the first time).
2. While holding down the Foot Switch, press the Tuning Button or
Mode Button to set the fret offset (-1 to -6 for drop tune, 0 for no
offset, or 1 to 6 for capo).
3. Once the offset you want is selected, release the Foot Switch. The
“Ready to Tune” state is re-entered after no button presses for 3
seconds.
NOTE: Setting the Fret Offset does not change the tuning reference. Therefore, when tuning while
using a Fret Offset, the true pitch of the note being played will be displayed. This means if A440
is the selected tuning reference and you set the Fret offset to +1 and then play the low E string
(without a capo), E will be the displayed note, which is the actual true pitch of the note.

DigiTech HARDWIRE HT-6 Specifications

General

Brand	DigiTech
Model	HARDWIRE HT-6
Category	Tuner
Language	English