DigiTech HardWire series User Manual

5
8. Foot Switch Release Pins - These two pins are spring loaded
hinges that hold the Foot Switch in place. See page 10 for information
on accessing and changing the battery. See page 6 for more information
about using and changing the Tails Switch settings.
9. Indicator LED - Lights when the effect is turned on. When battery
power is low (approximately 15 minutes), the Indicator LED begins to
dim giving you advanced warning that very shortly you will need to
replace the battery.
10. Foot Switch - Turns the effect on and off.
11. Output 1 (Mono) - Connect this output to the input of a single
guitar amplifier or amp effects return.
12. Output 2 - Connect this output to the input of a second guitar
amplifier when a second amp is being used.
Note: Use unbalanced mono instrument cables only.

DigiTech HardWire series Specifications

General

Construction	Metal Chassis
Power Supply	9V DC
Series	HardWire series
Power Requirements	9V DC (center negative)
Input Impedance	1M ohm
Output Impedance	1k ohm
Bypass	True Bypass