24
Why does the Harmony Key Display show that a key is set when I try to reset
the musIQ
TM
feature’s memory (by pressing, holding, and releasing the Memory
Select footswitch without playing a chord)?
When the musIQ memory is reset while the Harmony Effect is on, the manual
harmony key and scale are shown in the display until the Harmony is turned
off.
Why does the HarmonyMan
TM
suggest a different key from the one that I think
is correct for this song?
The musIQ feature will suggest the key that it determines will work best with
the current song. This may not always match the key and scale you would
choose for that song. If you want to try a different key and scale, you can
manually choose a key and scale (See “Manually Set the Key and Scale” on
page 9 for more information).
Why is the Harmony Key Display showing the same key instead of reacting to
my chord progression when using a single guitar (no Sidechain)?
Make sure the musIQ feature is enabled. The automatic key recognition is only
shown when the musIQ button is on.
Make sure the harmony function is turned off (by pressing and releasing the
Harmony On/Off footswitch until the On LED turns off). The key will not
change while the harmony function is engaged when no Sidechain signal is
connected.
Make sure there is no signal connected to the Sidechain Input. When a signal
is connected the Sidechain Input, the Sidechain signal is used to determine the
key and scale instead of the lead guitar signal.
Troubleshooting
To Next Page
Loading...
Need help?
General
