DigiTech HOT ROD User Manual

Connections
The Hot Rod has a single input (INPUT) and a pair of outputs (AMP and
MIXER). The two outputs give you the following options: running into a
guitar amplifier, running directly to a mixing console or recording device,
or both. The MIXER output uses DigiTech’s advance CIT™ cabinet
modeling technology for an authentic guitar amplifier sound without
using an amp.
Follow these setup directions:
1.Turn the volume down on the amplifier/mixer you are connecting to.
2. Connect the pedal output to the amplifier/mixer input.
3. Connect the guitar to the pedal input.
4. Connect the power supply to the pedal (optional).
5.Turn the level control on the pedal to the minimum position.
6.Turn up your amplifier/mixer level to the desired listening level.
7.Turn on the pedal by pressing the pedal switch and gradually turn up
the level to the desired listening level.

DigiTech HOT ROD Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply	PS200R - 100 (100V ~ 50/60Hz), 120 (120V ~ 60Hz), 230 (230V ~ 50Hz), 240 (240V ~ 50Hz)

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs.