DigiTech HYPER PHASE User Manual

6. Input Jack
Connect your instrument to this jack. Connecting a guitar cable to this
jack supplies battery power even though the Indicator LED may not be
lit. To prolong battery life, disconnect all cables from the pedal when not
in use.
7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the pedal chassis exposing
the battery compartment. (See battery replacement diagram).
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1(Mono) Jack
Connect this output to a single guitar amplifier or mixer channel when
only one amp or mixer channel is being used.
10. Indicator LED
This LED indicates when the effect is turned on. If the LED becomes
dim or does not light when the cables are connected, the battery needs
to be replaced.

DigiTech HYPER PHASE Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
battery life	Approximately 4 hours

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
optional power supply voltages	100V, 120V, 230V, 240V

Weight and Dimensions

dimensions	4 15/16”(L) x 3 1/8”(W) x 2 1/8”(H)
weight	1.38 lbs