Wireless Microphone & Receiver
User Manual
An easy to use UHF Wireless Microphone system perfect for a number of applications. The receiver,
rechargeable via USB, is a compact sized case with a 6.5mm jack that connects directly to an input of a
mixer or amplier. The unidirectional Lapel Microphone with 1.2m cable connects to a small transmitter that
clips onto your waist or ts into your pocket. The transmitter has a volume control and is also rechargeable
by USB. The systems effective range is 50m on average, making it ideal for street announcers/performers,
pubs, club functions, etc.
• Up to 50m Range
• Rechargeable
Frequency Response: 30Hz-20kHz
UHF Frequency Range: 700-730MHz
Transmission Range: Up to 50m
Maximum Radiant Power: 13dBm
Operating Time: 8~10 hours (@ 50% volume)
Charging Time: 3~4 hours
Battery Tx: 18650 Lithium 3.7V 1500mA
Battery Rx: 3.7V 750mA
Receiver: 105(L)x36(W)x19(D)mm, 45g
Transmitter: 85(L)x56(W)x27(D)mm, 92g
Plug the receiver into the Mic jack, turn on the audio device. Turn on the receiver and transmitter, plug the
lapel mic into the transmitter.
Step1: Plug the receiver into your Mic jack, and turn on your audio device.
Step2: Turn on the receiver and short press the pair button, at this time you should nd the blue indicator
ashes on the receiver.
Step3: Plug the lapel mic into the transmitter. Turn on the transmitter and long press the “Pair” key for
about 3 seconds, then you should nd the blue indicator lights on the receiver become constant
blue. It means that the receiver and transmitter are paired successfully.
No sound: The indicator lights are not being on: Please charge the receiver.
The indicator light of transmitter shows low: Please charge the transmitter.
Distinct howling: Please do not point the microphone toward the speaker and the distance between
microphone and speaker should be about 3M.
Please turn down the volume to avoid howling in a small room.
Introduction
Features
Specications
How to Use
UHF Manual Pairing
Troubleshooting
To Next Page
Need help?
General