Specifications:
Transmitter Frequency: 433MHz
Transmitter Range: 30m
Temperature Range: -20°C - 70°C
Console Power: 2 x AA Battery (not included)
Sensor Power: 2 x AA Battery (not included)
Console Dimensions: 220(W) x 141(H) x 36(D) mm
Sensor Dimensions: 97(W) x 50(H) x 32(D) mm
Important:
- The weather forecast will only be ready 12 hours after the batteries are
inserted.
- The radio communication between the receiver and the transmitter will reach
a distance of 30m line of sight. Obstacles in the way, such as buildings, trees
and high power voltage lines can interfere with the transmission.
- Radio interferences created by computer screens, radios, or TV sets can in
some cases cut off the radio communication entirely. Please take this into
consideration when choosing standing or mounting locations.
- Please keep the transmitter indoors if the outdoor temperature reaches below
-20°C.
Instructions:
- Open the battery compartment on the weather station and insert 2 x AA
batteries, taking care to put them in the correct polarity. Close the battery
compartment.
- Open the battery compartment on the transmitter and insert 2 x AA batteries,
taking care to put them in the correct polarity. Close the battery
compartment.
Note: Ensure to install the batteries into the weather station and transmitter
within the same hour to ensure that they synchronize properly.
Setting the connection to the outdoor sensors:
Once the battery is inserted into the transmitter, by default the transmitter
supplied with your weather station will be on Channel 1. Set the channel of the
transmitter on the back of the sensor.
- Press the ‘CHANNEL’ on the weather station to select a channel (1 to 3). This
gives you the option of polling 3 outdoor sensors with each weather station.
- Press and hold the ‘CHANNEL’ button for 2 seconds to search for outdoor
sensors.
To Next Page
Loading...
Need help?
General
