To Next PageTo Next Page
Need help?Do you have a question about the Digitone Call Blocker and is the answer not in the manual?
General| Type | Call Blocker |
|---|---|
| Compatibility | Landline phones |
| Caller ID | Yes |
| Display | LCD |
| Blocking Method | Blacklist |
| Phone Line Compatibility | Analog |
The unit maintains all program settings during power outages.
Explains how the Call Blocker handles default, invited, VIP, blocked, and OPX calls.
Manages first ring suppression and Caller ID pass-through modes using code 70.
Covers automatic routing, clearing history, viewing calls, and using display buttons.
Explains how to block, invite, and invite VIP callers directly from the display.
Instructions for viewing and removing entries from the blocked caller list.
How to view and remove entries from individual and blocked area code invited lists.
Instructions for viewing and removing entries from the VIP caller list.
Steps to enter the programming mode using the Program button.
How to disable global invite and set up a personalized invited caller list.
Factory default settings and procedures for deleting numbers from all lists.
Covers inviting VIPs, area codes, specific numbers within blocked codes, and blocking individuals.
Default mode allowing most calls with numbers to ring through.
Mode for businesses to allow all callers except blocked ones to ring.
Mode where the TEL phone port rings normally and the device indicator blinks.
Steps to set start and end times for After Hours Mode and enable/disable periods.
Using code 72 to allow these call types to ring through to voicemail or answer machine.
Enables specific call types to ring through while blocking others.
Covers dialing numbers, displaying codes, setting clock/date, and resetting user settings.
Addresses programming prompt visibility and why callers cannot leave messages.
Explains interference from other devices and issues with blocking area codes.
Discusses allowing Out of Area calls and why some calls may not be blocked.
How power issues affect the device and instructions for performing a soft reset.
Steps to perform a full factory reset, clearing all settings and lists.
Instructions for connecting the Call Blocker to a 2-line phone system.
Explains installation at the demarc for coverage of all phones in the house.
Procedure for obtaining warranty service and returning the product.
States that the device complies with Federal Communications Commission rules.
Provides website and contact details for obtaining technical support.
