Getting started
The first connected insoles that allow the user to warm his or her feet while analysing physical activity.
Package contents
In the box, you will find:
• A pair of Warm Series insoles
• A user manual
• A cable (1 Micro USB 2.0 USB – XGW08-047-02)
Safety and handling
Important safety and handling information for your Warm Series insoles.
Battery
STANDBY MODE: The insoles are programmed to go into "standby mode" if they are not connected to
a phone, when no movement is detected for five minutes. This mode is designed to save battery power
when the insoles are not in use. When the insoles are in standby mode, the red LED does not flash. A
simple shake of the insoles will wake them up, and the light will start flashing again.
Do not attempt to remove or replace the batteries built into the insoles, as this may damage them.
Please refer to page 31 for instructions on battery and insole recycling.
Exposure to moisture, heat, dust and other elements
The connected insoles have a protection class of IPX6 and are water resistant.
The battery can be damaged by temperatures above 100 °C.
To Next Page