Installation of Hard Drive
1. Open the enclosure
2. Place hard drive into the enclosure
3. Connect included IDE or SATA cable to hard drive
4. Tighten screws on the enclosure to hold the hard drive in place
5. Screw the enclosure back together
6. Connect power cable to enclosure
7. Connect USB cable to USB port on device
8. When attached to PC or device, click 'My Computer' and hard
drive will appear.
9. No additional drivers required.
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the requirements of
Directive 2014/30/EU and the Directive 2011/65/EU for RoHS compliance. The complete declaration of
conformity can be requested by post under the below mentioned manufacturer address.
Warning:
This device is a class B product. This equipment may cause some radio interference in living environment. In
this case, the user can be requested to undertake appropriate measures to prevent interference.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
To Previous Page
Loading...
