15
8. Common fault treatment
Adjust the desk downwards
To set Height Preset, press the M button until LED Display
flashes then Preset 1, 2, 3 or 4 to program preset
Error Code Troubleshoot (Shown on LED Display)
protection
Alarms when continuously in motion for 2
minutes.
Power back on and wait for at least 18 minutes
before adjusting height again.
alarm
Alarms when motor sensor cannot be detected.
Turn off power, check the connection of motor
and control box, and then power back on.
protection
If alarm sounds when the desk is moving up,
remove loads off the desk and try again. If it
To Next Page
Loading...
