Digitus DA-90453 - Page 16

16
alarms when desk is moving down, turn off the
power, remove loads off the desk and re-try.
E02
Rebound
protection
Alarms when vibrated, collided or inclined during
height adjustment. Check if there is anything
in the way of desk motion. Then proceed to the
reset the motor.
E32
Overvoltage
alar
It alarms when voltage is higher than anticipated
value. Turn the power off, check the connection
between power and control box. If no problem,
power it back on.
E31
Undervoltage
alarm
It alarms when voltage is lower than required
value. Turn the power off, check the connection
between power and control box. If no problem,
power it back on.
E60
Step out
alarm
It alarms when height difference between left leg
and right leg exceeds the set value.
Power off first. Check whether the left leg and
the right leg are in the same height. If not, re-do
Installation Step 4 to make them same height.
Power it back on.
Breaking
protection
It stops and enters protection state when motor
cables o r manual control cables are removed
or disconnected accidentally; goes back to
normal after it’s reconnected and alarm is
cleared.
Engineering Mode
Change Displayed Unit (Un)
Press and hold the button until
“M” shows and flashes. Press “M”
again and the display shows “Un”.
Press to select. Press  or  to
switch between (metric) or
(imperial).
Press “M” to save your selection
Change Brightness (br)
Press and hold the “M” button,
until “S--”shows and flashes. Press