Digitus DN-13001-1 - Hardware and Software Installation; Hardware Installation; Software Installation

2
Before you start, y ou should prepare the following items:
 One Windows-based PC with print server setup CD
 One printer
 One printer cable
 One HUB
W i red Network with Print Server:
Printer
Print Server HUB
Computer Computer Computer
Hardware Installation:
1. Turn off the printer’s power.
2. Connect the print server to your printer with the supplied printer cable.
3. Turn the printer’s power on.
4. Plug the AC power adapter into the power connector on the print server.
5. Wait 10 seconds as part of the print server’s Power On Self Test (POST).
Software Installation:
1. To enable network communication with print server,
your computer must have a proper IP address, e.g. 192.168.0.100
2. Insert the setup CD into your CD-drive, and the following message appears.