Need help?Do you have a question about the Digitus DN-13006-1 and is the answer not in the manual?
General| Networking standards | IEEE 802.3, IEEE 802.3u |
|---|---|
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Network connection type | Ethernet LAN |
| Web-based management | Yes |
| Supported network protocols | TCP/IP |
| USB connector type | USB Type-A |
| Serial ports quantity | 0 |
| USB 2.0 ports quantity | 2 |
| Ethernet LAN (RJ-45) ports | 1 |
| Internal | No |
| Product color | White |
| Country of origin | Taiwan |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Package type | Box |
Outlines prerequisites and essential steps for physical installation.
Details initial steps for installing PSAdmin software and driver.
Guides through launching and initiating the setup wizard.
Explains how to select the print server from detected network devices.
Allows modification of basic print server settings like IP address.
Guides on selecting an existing or adding a new printer to the server.
Instructs on selecting the appropriate printer port (e.g., LPT1).
Guides on selecting the correct printer manufacturer and model.
Explains how to use the PSAdmin utility for managing the print server.
Guides through configuring TCP/IP settings for the print server.
Details steps for configuring the print server for NetWare environments.
Details manual IP address, subnet mask, and gateway configuration.
Instructions for upgrading the print server's firmware.
Explains how to reset the print server to factory default settings.
Steps to configure the print server to service multiple print queues.
Explains prerequisites and steps for accessing the web server.
Displays the current status of printers connected to the print server.
Shows the current TCP/IP configuration of the print server.
Displays current SNMP settings for network management.
Configures SNMP community names and privileges for access.
Sets the administrator password for web access and security.
Configures TCP/IP settings, including DHCP and static IP.
Sets up NetWare NDS mode, tree, and context.
Sets up NetWare Bindery mode and file server.
Details installing the print server on NetWare 4.x/5.x systems.
Step-by-step guide for NetWare installation.
Steps to add a printer using the LPD protocol on Mac.
Explains the SNMP protocol for network device management.
Methods for assigning an IP address to the print server.
Configuring LPR printers with server IP and queue names.
Steps for standard TCP/IP port printing installation on Windows.
Configuring LPR protocol and queue names for TCP/IP ports.
Steps to upgrade firmware using the PSAdmin utility.
Steps to upgrade firmware via TCP/IP from Windows systems.
Steps to upgrade firmware via TCP/IP from UNIX systems.
Steps to upgrade firmware using the print server's web interface.
Troubleshooting common issues with TCP/IP LPR port printing.
Explains how to reboot and perform a factory default reset.
To Next Page
