EasyManua.ls Logo

Digitus DN-13006-1 - Network Print Monitor Setup

Digitus DN-13006-1
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
6. Network Print Monitor
Preparation
The print server supports TCP/IP, IPX/SPX and NetBEUI protocols under Windows system.
Please make sure that the following steps have been completed before proceeding with
installation under Microsoft Windows 95/98/ME/NT4/2000/XP 32bit edition or server 2003
32bit edition.
Select A Desired Protocol
TCP/IP
The TCP/IP Protocol must be installed. For further information, please read “TCP/IP
Protocol Installation” section in this chapter.
Note: If TCP/IP protocol is chosen, please refer to “Assigning an IP Address to the print
server” section later in this chapter.
IPX/SPX
The IPX/SPX-compatible Protocol must be installed. For further information, please read
IPX/SPX-compatible Protocol Installation” section in this chapter.
NetBEUI
The NetBEUI protocol must be installed. For further information, please read “NetBEUI
Protocol Installation” section in this chapter. The Microsoft Windows XP/2003/Vista/7/8/10
does not support the NetBEUI printing.

Table of Contents

Other manuals for Digitus DN-13006-1

Related product manuals