Digitus DN-13003-1 - Print Server Installation Guide; Preparation and Supported Networks

8
 Enter the proper SSID of your wireless network.
- Channel: optional
- Data Transmit Rates: select Auto or others
- Transmit Mode: select Auto or others
 On the Wireless Security screen, enable or disable WEP/WPA/WPA2 encryption,
configure according to your wireless network and click Next.
 On the TCP/IP Settings screen, specify a fixed or dynamic IP address for the print
server, a fixed IP address is highly recommended. Click Next.
7. In the setup wizard, select an already configured printer from the list, click Next, Next
and then Finish to complete the installation.
or
Select Add New Printer if the print server is connected to a printer that hasn’t been
installed before and does not appear in the list.
Note:
The IP address of print server must be within the same subnet as your network adapter.