Digitus DN-14001-1 - Operation; Loopback Test


3.0 Operation
3.1 Loopback Test
• 10Base-T Cable Test
1. 
and another e
2. 

mode.
Note: 


3. Choose the  switch to be Auto scan mode or  scan
mode by pressing the  switch.
4. In this moment the corresponding LED indicators of another row of LED
  up simutaneousIy.
  
  in the  run of
LED  you may read it again in the the test switch one by one 
you read the  out.
Loopback
Test