2
1. Introduction
DN-95358 is a 16-port 10/100/1000Mbps PoE + 2G Gigabit RJ45 +2 Gigabit SFP
PoE switch. The PoE ports can automatically detect IEEE 802.3af/at-compliant
Powered Devices (PDs) and supply them with power. Your network is able to
extend power and data transmission via a single cable to locations where there
are no power lines or outlets that you could use to install devices such as APs, IP
cameras or IP phones and the like. The PoE switch offers a simple, cost-effective
and non-blocking wire-speed performance with 11-inch metal form for rack
installation in office or department networks.
2. Features
16*10/100/1000Mbps PoE RJ45 connections
2*10/100/1000Mbps RJ45 connections
2*1000Mbps SFP connections
Standard: IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3z, IEEE802.3x
Corresponds to IEEE802.3af/at Power over Ethernet
PSE Power on RJ45: Mode A 1/2(+), 3/6(-), Mode B 4/5(+), 7/8(-)
Supports PoE power up to 32W for each PoE port
PoE power budget: 185W
Energy supply: 200W
Automatic detection of power supply device
Remote supply of power and data up to 100 m
Flow control for full duplex operation and back pressure for half duplex
operation
Supports VLAN and CCTV function
8K MAC address, automatic address learning and address aging
Supports energy-efficient Ethernet (EEE) function EEE802.3az
Supports the PD alive function
LED: PWR, PoE, LINK/ACT, PoE Max
Transmission mode: Store and forward
Switching capacity: 40Gps
Packet forwarding rate: 29.76Mpps
Packet buffer: 4M bit
To Next Page
Loading...
