11
8. Pairing a Transmitter (TX) and Receiver (RX)
The Wireless Collaboration System (DS-55317) includes 1x Receiver (RX) and 2x
Transmitter (TX) units, which are paired already together. Normally you don’t
need to pair them again.
However, if you need to re-pair or buy an additional Transmitter (DS-55322),
you need to follow the instruction below to pair the new transmitter with the
receiver.
1. Power on the Receiver (RX) and connect it with the display, please make
sure to use USB Power Adapter for the RX
2. Connect the USB cable (USB-A plug) of the Transmitter (TX) to the USB-A
port of the Receiver
3. Wait around 15 seconds, the button light of TX will turn to constant blue
from red light, and “pairing successful” message will be displayed
on the RX screen
Remark: Repeat the process if needed
9. TX and RX Software Upgrade Guide:
The TX and RX already coming with the latest software, you don’t need to
upgrade them. In case there will be any software update released in the
future, please follow below upgrade guide for software update.
Please always upgrade TX firstly before you upgrade RX.
To Next Page
Loading...