8
7. Streaming
7.1 Streaming from Transmitter
1. Connect the Transmitter HDMI Unit to a PC HDMI port
Remark: if the source devices HDMI with 5V power output, then
there is no need to connect a USB cable for power, if not, please
connect the Transmitter Unit with PC by USB cable for power.
To have a safe and stable operation, we recommend to use always
the Micro USB cable for power supply of TX and RX
2. The LED indicator of the Transmitter will turn red when it’s
booting up
3. The LED indicator will become blue and flashing when it is ready
to stream
4. Click the button to start casting, the LED indicator will become
constant blue
8. Pairing Transmitter and Receiver
The set DS-55319 includes one receiver and one transmitter, which are
paired before shipment. Normally you don’t need to pair them again.
However, if you buy an additional transmitter (DS-55320) or need to
re-pair, you need to follow the instruction below to pair the new
transmitter with the receiver.
1. Power on receiver and connect with display
2. Power on the transmitter till the LED turn to flash red, then press
the button up to 5 seconds till the LED become fast flashing red,
this means the transmitter unit is in factory reset mode.
To Next Page
Loading...