Dimplex 402E - User Manual

CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
WARNING: Do not use the heater in small rooms
when they are occupied by persons who are not
capable of leaving the room on their own, unless
constant supervision is provided.
WARNING: To reduce the risk of re, keep
textiles, curtains or any other ammable material
a minimum distance of 1m from the air outlet.
Do not use the heater if it has been dropped.
Do not use the heater if there are any visible
signs of damage.
If the mains lead is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualied person in order to avoid a
hazard.
The heater should only be used on a horizontal
and stable surface with the feet securely tted
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED
The use of an extension lead or multi-plug adaptor is not advised when
connecting this product to the mains. Connection through these devices
could lead to a risk of overloading, overheating and even re at the extension
lead or adaptor due to inadequate connection quality.
This heater must be used on an ~ supply only and the voltage marked on
the heater must correspond to the supply voltage. This heater is tted with
a rewireable plug incorporating a 13 amp fuse. In the event of replacing
the fuse in the plug supplied, a 13 amp fuse approved by ASTA to BS 1362
must be used. If any other type of plug is used, a 15 amp fuse must be
tted in the plug, the adaptor, or at the distribution board.
IMPORTANT : If the plug is not suitable for your socket, the 13 amp plug
should be removed. Before wiring the appropriate plug, please note that
the wires in this mains lead are coloured in accordance with the following
code : GREEN AND YELLOW: EARTH
BLUE : NEUTRAL
BROWN : LIVE
Connect the GREEN AND YELLOW wire to the terminal marked ‘E’ or
by the earth symbol ‘ ’ , or coloured GREEN or GREEN AND YELLOW.
Connect the BROWN wire to the terminal marked ‘L’ or coloured RED.
Connect the BLUE wire to the terminal marked ‘N’ or coloured BLACK.
Important Safety Advice
WARNING: This appliance must not be used in
a bathroom.
WARNING: Do not use this heater in the
immediate surroundings of a bath, a shower or
a swimming pool.
WARNING: This heater must not be located
immediately below a xed socket outlet.
The heater carries a warning symbol to
alert the user to the risk of re that exists
if the heater is accidentally covered.
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience or knowledge if they have
been given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children shall
not play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug
in, regulate and clean the appliance or perform
user maintenance.
Dimensions
(Millimetres)
Installation and Operating Instructions
Dimplex Convector Heater
Models : 402E
08/52811/0 Issue 2
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
As with all portable heating appliances - This product is only suitable for well insulated spaces or occasional use
Fig. 1

Summary

Dimplex Convector Heater 402 E

General Safety Advice

Important warnings for safe usage, including prohibitions in bathrooms and near water.

Child Safety and Usage

Guidelines for children's use, supervision requirements, and age-specific restrictions.

Electrical Connection and Safety

Instructions on earthing, mains connection, fuse replacement, and wiring.

Using the Dimplex Heater

Initial Setup and First Use

Ensuring feet are fitted correctly and handling initial fuming and ventilation.

Heater Placement and Assembly

Guidance on positioning the heater safely and assembling the feet securely.

Control Panel and Operation

Overview of controls, operating modes, temperature setting, and standby.

Display and Indicator Lights

Explanation of the LCD display features and the indicator neon light.

Advanced Features and Safety

Timer Functions

Details on using Runback Timer and Delayed Start modes for timed operation.

Power Select Mode

Instructions on how to adjust the heater's power output settings.

Overheat Protection

Explanation of the automatic thermal cut-out and how to reset it.

Important Usage Notes

Information on carpet discoloration, element appearance, and grille discoloration.

Cleaning, Guarantee, and Contact

Cleaning and Maintenance

Instructions for safely cleaning the heater exterior.

Guarantee Terms and Conditions

Details on the 3-year guarantee, coverage, exclusions, and statutory rights.

Contact Information

Contact details for Dimplex customer service and technical support.

Dimplex 402E Specifications

General

Brand	Dimplex
Model	402E
Category	Heater
Language	English