Dimplex Duo300n - Wall Mounted Programmers; Programmer Modes and Settings; Cleaning Instructions; Guarantee and Contact Information

To Previous Page

- 4 -

Wall Mounted Programmers (only applicable if Programmer is ﬁ tted to DuoHeat installation)

The programmer has two modes (i) AUTO or (ii) MANUAL

(i) In “Auto” mode, the radiator will change between Comfort and Setback modes (as shown in the table below) depending on your seven day

programme. To change the programme settings or temporarily over ride the programme, see the appropriate programmer instructions.

(ii) “Manual” mode will override the auto programme setting. There are four “Manual” mode settings shown in the table below.

RXPW4 - Pilot Wire, or

RXMBS4 - Mains Borne Signalling

Note: It will take 24 hours for room temperature to reach a comfortable level when resetting from “Frost Protect”

or “Off” to “Comfort”.

Programmer Mode Temperature Setting DuoHeat Radiator –

“Temperature control display setting”

Comfort Setting (radiator setting). Each Display will remain as shown in Operating

Comfort Radiator will operate as set in “controls” Instructions

section of Operating Instructions.

Setback will reduce the Comfort setting by Display will show two red bars less.eg. if “Comfort”

Setback 2°C, and will leave the Background displays 5, “Setback” will display 3 red bars/Child-

unaffected. lock LED Green

Frost Protect Room temperature will be maintained at Childlock LED green / Frost protection LED blue.

14°C with Background operating.

This will completely switch off radiators,

Off e.g. during the summer heating may not be Childlock LED Green, all other LED’s off.

required.

Cleaning - WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE RADIATOR.

To maintain the external appearance of the radiator it need only be wiped over occasionally with a dry duster. Allow the radiator to cool, then wipe with

a dry cloth to remove dust and a damp cloth (not wet) to clean off stains. Be careful not to allow moisture into the radiator. Do not use abrasive cleaning

powders or furniture polish.

Discoloration of wall ﬁ nishes can sometimes occur immediately above a radiator due to the properties of some paints and decorating materials or the

presence of environmental impurities in the air (such as soot or incense generated from the burning of candles etc.).

After Sales Service

Your product is guaranteed for two years from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge

(subject to availability) provided it has been installed and operated in accordance with these instructions.

Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.

Should you require after sales information please go to www.dimplex.co.uk where you will ﬁ nd our self help guide by clicking on ‘After Sales’ or ring our

help desk on 0845 600 5111 (UK) or 01842 4833 (ROI). Spare parts are also available on the web site www.dimplex.co.uk.

It would assist us if you can quote the model number, series, date of purchase, and nature of the fault at the time of your call. The customer services

help desk will also be able to advise you should you need to purchase any spares. Please do not return a faulty product to us in the ﬁ rst instance as this

may result in loss or damage and delay in providing you with a satisfactory service.

Please retain your receipt as proof of purchase.

Dimplex UK Limited

Millbrook House

Grange Drive

Hedge End

Southampton

Hampshire SO30 2DF

This appliance complies with the European Standards EN60335-2-30, EN 60 335-1, EN 60 335-2-61, EN 61000-3-2,

EN 61000-3-3, EN 55014 and EN55104 for Safety & Electromagnetic Compatibility.

These standards cover the requirement of the EMC Directives 89/336 & 73/23

RECYCLING