To Next PageTo Next PageHow to fix yellow flame on Dimplex Heater?
If the flame on your Dimplex Heater is yellow, several factors could be the cause. Start by checking the gas pressure and adjusting it as required. Then, inspect the injector and clean it if necessary. Also, check the venturi for dust and clean if necessary. Finally, examine the burner ports for any blockage and clean them if necessary.
What to do if the pilot or main burner of Dimplex Heater will not light?
If the pilot or main burner of your Dimplex Heater won't light, it could be due to several reasons. First, there might be insufficient gas supply, in which case you should rectify the gas supply. If the igniter isn't sparking, try replacing the battery. Another potential issue is air in the gas line, requiring you to purge the gas line. Finally, a blockage in the gas line could be the culprit; trace back and clear any obstructions.
Why Dimplex DGR32WNG Heater main burner will not light fully?
If the main burner of your Dimplex Heater isn't lighting fully, it could be due to insufficient gas. Rectify the gas supply to resolve this. A poor gas supply could also be the reason; trace the supply back to the source and clear any obstructions. Alternatively, the gas control might be inoperative, requiring you to inspect the valve and rectify any issues.
General| Model | DGR32WNG |
|---|---|
| Fuel Type | Electric |
| Heating Area | 400 sq. ft. |
| Vent Type | Vent-Free |
| Control Type | Manual |
| Thermostat | Yes |
| Overheat Protection | Yes |
| Remote Control | Yes |
| Power | 1500W |
| Voltage | 120V |
| Heating Method | Forced Fan |
| Ignition System | Electric |
| Flame Effect | Yes |
Installation must conform with local and national codes for safety.
Regulator must be used on heater, set to operate at 4" W.C. outlet pressure.
Use only Dimplex replacement parts to avoid danger and voiding warranty.
Specifies required clearances around the heater for safe operation.
Steps to take before assembly, including checking parts and tools.
Lists necessary tools for installation, like gloves and screwdriver.
Instructions for attaching the heat deflector using hardware.
Guide for inserting the battery into the compartment.
Steps to secure the regulator hose to the heater using hardware.
Details on mounting the bracket to the wall using fasteners.
Instructions for attaching the heater to the installed mounting bracket.
How to connect the red and black cords to the trigger.
Specifies the appliance is for natural gas only and pressure requirements.
Safety precautions for using natural gas with the heater.
Steps for connecting the natural gas hose to the heater and supply.
Procedure for checking gas connections for leaks using soap solution.
Step-by-step guide on how to light the heater.
Instructions on how to safely turn off the heater.
How to clean the exterior of the heater safely and effectively.
Steps for replacing the battery in the igniter.
Details the terms and duration of the residential limited warranty.
Specifies the types of products and regions covered by the warranty.
Lists products and conditions not covered by the limited warranty.
Explains what the warranty covers and its duration.
Outlines exclusions from the limited warranty, such as misuse or alterations.
Instructions on how to obtain warranty service, including contact information.
Details the manufacturer's responsibilities for defects under warranty.
Explains the application of state and provincial laws to the warranty.
Lists liabilities that the manufacturer and its agents are not responsible for.
