Dimplex Girona - User Manual

Installation and Operating Instructions
INDGAUP7RG Issue 0
Girona Panel Heaters
Dimensions
(millimetres)
Model(s) Watt A B
GFP200 W 2.0kW 940 107
GFP200 B 2.0kW 940 107
Important Safety Advice
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electrical shock, and injury to persons, including the
following:
IIMPORTANT – The wall bracket supplied with the
appliance must be used.
WARNING - DO NOT USE THIS HEATER IN THE IMMEDIATE
SURROUNDINGS OF A BATH, A SHOWER OR A SWIMMING
POOL.
IMPORTANT – If the heater is installed in a room
containing a bath or shower, it must be so installed that
switches and other controls cannot be touched by a
person using a bath or shower.
Do not use outdoors.
Do not locate the heater immediately in front of or below
a fixed socket outlet or connection box.
Do not cover the heater. Do not place material or
garments on the heater, or obstruct the air circulation
around the heater, for instance by curtains or furniture,
as this could cause overheating and a fire risk.
NEVER cover or obstruct in any way the heat outlet slots
at the top of the heater or the air inlet slots in the base of
the heater.
The heater carries the Warning symbol indicating
that it must not be covered.
WARNING – THE SURFACES OF THIS HEATER CAN BE HOT.
Momentary contact with any part of the heater should
not cause injury.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
Note that due care and consideration must be taken
when using this heater in series with a thermal control,
a program controller, a timer or any other device that
switches on the heat automatically, since a fire risk
exists when the heater is accidentally covered or
displaced.
If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent.
Fig. 1
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Electrical
WARNING – THIS APPLIANCE MUST BE EARTHED
The heater is fitted with a cable and plug. The length of flexible
cable type H05VV-F size 3 x 1.0mm
2
on all models.
General
The heater is designed for wall mounting on the wall bracket
supplied. It should only be operated when in the upright
position - see Fig. 1.
All models are splashproof to IPX4 standard and may be
used in bathrooms, however not in the immediate vicinity of
baths, showers, water connections, wash basins or
swimming pools.
Before connecting the heater check that the supply voltage is
the same as that stated on the heater.
Wall Mounting
IMPORTANT – The wall bracket supplied with the appliance
must be used. The heater should be positioned observing
the minimum clearances stated around the heater - see
Fig. 1.
DO NOT locate the heater immediately below a fixed socket
outlet or connection box.
1. Remove wall mounting bracket from the back of the
heater by depressing the spring latch at the top of
each bracket - see Fig. 2.
2. Fix the wall bracket securely to the wall through the
four screw holes provided.
3. Present the heater to the wall bracket, and engage
lower slots in the back with bracket.
4. Raise the heater to upright position and push the
heater onto bracket to engage top latch.
A
565
B
150
Min.
300 Min.
shelf
150 Min.
D
255 Min.
C
C D
GFP200W 800 300
GFP200B 800 300
Fig. 2
AUS/NZ

Summary

Safety and Installation Guidelines

General Electrical Safety

Basic precautions for electrical appliances like fire, shock, and injury risks.

Water Area Restrictions

Heater must not be used in immediate vicinity of baths, showers, or swimming pools.

Hot Surface Warning

Heater surfaces can be hot, but momentary contact should not cause injury.

Wall Mounting Instructions

Use supplied bracket; position heater observing clearances; secure bracket and heater.

Heater Operation and Control

Switching the Heater On

Locate controls on top right, lift flap, use 'ON' button.

Adjusting Temperature Settings

Use thermostat slider to control room temperature; ')' symbol indicates heating.

Background Temperature Function

Heater adjusts to 5°C less than setting with remote controllers in background mode.

Limiting Thermostat Movement

Installer can limit slider movement using plastic pins for fixed settings.

Accessory Module Installation

Fitting Control Modules

Switch off heater, remove protective cover, insert module into slot.

Safety and Maintenance

Overheat Protection System

Appliance has a thermal cut-out that prevents overheating by cutting power; it resets automatically.

Cleaning Instructions

Disconnect power, use damp cloth, dry; do not use abrasive cleaners.

Product End-of-Life and Support

Recycling Guidelines

Dispose of electrical products responsibly; check local authority for recycling advice.

After Sales Service Information

Contact supplier or warranty leaflet for service; retain receipt as proof of purchase.

Energy Saving Tips

Heating and Hot Water Efficiency

Tips to reduce energy use, including thermostat settings, room usage, and insulation.

General Household Efficiency

Tips for saving energy on lighting and cooking.

After Sales Contact Details

Contact information for Glen Dimplex Australasia and Australia offices.

Dimplex Girona Specifications

General

Brand	Dimplex
Model	Girona
Category	Heater
Language	English