Need help?Do you have a question about the DimSport RapidBike EVO and is the answer not in the manual?
General| Category | Motorcycle Accessories |
|---|---|
| Fuel Management | Yes |
| Ignition Management | Yes |
| Lambda Sensor Management | Yes |
| Self-Adaptive Mapping | Yes |
| Quickshifter Ready | Yes |
| Engine Brake Management | Yes |
| Compatibility | Various motorcycles |
| Connectivity | USB |
| Adjustment Parameters | Fuel |
| Power Supply | 12V |
| Operating Temperature | -20°C |
Turn off engine, remove seat/tank, then connect Rapid Bike harness to injector connectors.
Connect wiring to TPS, Crankshaft, and O2 sensor stock connectors as per instructions.
Connect the power supply wiring and finalize connections to the Rapid Bike module.
Fix the Rapid Bike control unit, check connections, and reassemble motorcycle parts.
Connect accessories like quickshifter, and follow specific notes for installation variations.
To Next Page