When paint is sprayed, it runs
down the wall or sags.
Material is going on too thick.
Choose a spray tip with smaller
hole
size.
Choose spray tip with wider fan.
Make sure gun is far enough
from
surface.
When paint is sprayed, coverage is
inadequate.
Material is going on too thin.
Choose spray tip with larger hole size.
Choose spray tip with narrower fan.
Make sure gun is close enough
to
surface.
Fan pattern varies dramatically
while
spraying.
Pressure controlswitchisworn
and
causing excessive pressure
variation.
Take sprayer to DINO-POWER
authorized service center.
Cannot trigger airless spray
gun.
Spray gun trigger lock is engaged.
Rotate trigger lock to
disengage trigger lock.
Paint is coming out of
pressure
control switch.
Pressure control switch is worn.
Take sprayer to DINO-POWER
authorized service center.
Paint is leaking through drain tube.
Sprayer is over pressurizing.
Take sprayer to DINO-POWER
authorized service center.
Paint leaks down outside of pump.
Motor is hot and runs
intermittently. Motor automatically
shuts off due to excessive heat.
Damage can occur if cause is not
corrected.
Vent holes in enclosure are
plugged or sprayer is covered.
Keep vent holes clear of
obstructions and overspray and
keepsprayer open to air.
Extension cord is too long or not
a
heavy enough gauge.
Unregulated electrical generator
being used has excessive
voltage.
Use electrical generator with a
proper
voltage regulator.
Motor needs to be replaced.
Take sprayer to DINO-POWER
authorizedretailer,distributor,
or
service center.
To Next Page
Loading...
Need help?
General
